Start with quality fruit!  Fall Bright is where great wines begin.   Tom Mitchell has been striving to grow quality grapes with attention in the vineyard from pruning to harvest.  While you are waiting for the grape harvest, how about making wine from the many fruits available throughout the summer, like strawberries, elderberries and peaches.  Let us help you with your fruit wines!  Approach fruit wine making with a basic understanding of important factors in winemaking: sugar and acid content of the juice, quality of fruit and yeast choice.

    For instance, in the many different varieties of grapes (30) that we handle, we see readings in acid and sugars vary widely.  The same will be true of say - strawberries, depending on variety and ripeness.  Without knowing the percentage of sugar and the resulting acid in the fresh fruit/water combination, how can one rely on a "recipe" to add sugar and acid?       

    In general winemaking we adjust acids up or down according to an acid (test kit) reading to around .7or.75(%) TA (total acidity).  For best results, take an acid reading on your recipe mix of fruit and water, adjust accordingly, slowly, and retest.  One of our favorite winemakers adds half of what acid he calculates he needs and retest.

 

    Sugar is easy to test before fermenting using a hydrometer.  This is an inexpensive but necessary tool.  If you add too much sugar, the yeast will ferment until the wine is too high in alcohol and too toxic to support yeast life.  This wine is hot to taste and could still be too sweet.  A normal reading for initial sugar in winemaking is around 21-23% or Brix.  Once you have your sugar reading it is easy to calculate an increase.  We use corn sugar, as it is a simple sugar, readily available to the yeast and it dissolves instantly.  Sucrose, if used, should be heated in your juice, as the acid and heat convert it to simple sugars.  If using honey instead of sugar, boil and skim to remove impurities. 

 

     Use our sugar chart sugar chart or easy math in www.101winemaking.com to calculate the correct amount of sugar to adjust to 21-23 percent. Three (3) cups of corn sugar is approximately 1 pound and 2 1/4 cups of cane sugar is about 1 pound.  These simple tests with proper adjustments will save you some strange experiences.  Keep notes!

    All of your recipes should recommend the use of pectic enzyme.  This enzyme aids in the release of juices during pressing by breaking down pectin, which can also cause a haze.  Cover any mashed fruits with clear plastic while sitting on pectic enzyme to reduce browning from air exposure (oxidation).

    Use quality fruit!  If you are not using premium fruit, you will not make premium wines!  If your peaches have brown spots on them, your wine will taste oxidized from the start as the brown spots are oxidized fruit!

    We recommend the use of campden tablets (sodium or potassium metabisulfite) or potassium metabisulfite (in a pure powder form). These additives are antioxidant and antibacterial agents.  Oxidation in wine results in browning and off flavor.  As an antibacterial agent, they prevent vinegar.

    Yeast nutrient is necessary to balance the fruit nutrients for the use of wine yeast.  We encourage the use of Enovit, which is a yeast nutrient with added vitamins, etc.  Yeast recommendations for fruity wine finishes are Red Star's Cotes des Blanc or Lalvin D-47 or 71B-1112.  These are slow steady fermenters retaining fruit taste and aromas. Many old time recipes call for champagne yeast, as it was readily available years ago.  It will ferment to a higher alcohol and retain less of the fruit aromas. 

    Stop by, call or shop online at www.fallbright.com.  Go to our new site for 'May Your Wines Fall Bright' at www.101winemaking.com!